Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-20-2001, 10:48 AM
|
#2 |
|
Registered Member
Join Date: Sep 1998
Location: Dayton, OH., United States
Posts: 467
|
I'd would also replace the stock aluminum bearing retainer with a new steel bearing retainer. Cost is about $40.00 so its not too bad. You might also want to consider putting new bushings and trans mount on the cross member since it will be off too. I replaced mine with Energy suspension polyurethane bushings and mount.
------------------ 88GT 5-speed Mods: Cervinis Ram air hood 3.73 gears, King Cobra clutch, Pro 5.0, March alum. Pullies, DynoMax Cat-back, WMS Xtrac subframes, 16" Ponies. "Nip it in the Bud" My Webpage |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice needed for a clutch replacement in a 2000 GT | GLDNPNY | Modular Madness | 2 | 03-06-2003 10:07 AM |
| Loose Sloppy Clutch In 2001 Gt | steedamustang01 | Modular Madness | 4 | 05-20-2002 11:03 AM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Smoked my clutch | bri32z | Blue Oval Lounge | 2 | 11-01-2001 09:52 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |