Clutch advice for '93 GT

NOS_Notch · 04-21-2001, 10:36 AM

Yeah the motorsport HD will make you happy. And do the steel bearing retainer...the stocker will groove out..(if it hasn't already)
Replace the stock quadrant(hardest part is getting the plastic stock one off)
And the energy suspension tranny mounts are awesome too. it's pretty easy...do it yourself, and w/ the money you save do an h-pipe back replacement(it all has to come off...you might as well make it real easy and cut it all off) I can do the swap myself in about 4 hours now.
The clutch, plate and T.O. bearing come in the motorsport kit...you should get an alignment tool($5)....and do the rear main seal while your in there...(takes about 10 minutes only) you will need the pilot bearing though...i never replaced mine, but think it just pops out.
The summit adj. cable looks identical to the rest for around $79.
Good luck.................

------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com

11's coming soon!!!!
Heads,intake and cam are all here

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Advice needed for a clutch replacement in a 2000 GT	GLDNPNY	Modular Madness	2	03-06-2003 10:07 AM
Loose Sloppy Clutch In 2001 Gt	steedamustang01	Modular Madness	4	05-20-2002 11:03 AM
'65 - Pull Away Problems - Action Plan	geordie	Classic Mustangs	0	05-14-2002 01:43 PM
Smoked my clutch	bri32z	Blue Oval Lounge	2	11-01-2001 09:52 PM
billed 5 times to install clutch by Pauls Auto, please read and give opinions (long)	beefcake	Blue Oval Lounge	2	02-23-2001 03:05 PM

04-21-2001, 10:36 AM	#4
NOS_Notch Registered Member Join Date: Sep 2000 Location: Fresno,CA. USA Posts: 384	Yeah the motorsport HD will make you happy. And do the steel bearing retainer...the stocker will groove out..(if it hasn't already) Replace the stock quadrant(hardest part is getting the plastic stock one off) And the energy suspension tranny mounts are awesome too. it's pretty easy...do it yourself, and w/ the money you save do an h-pipe back replacement(it all has to come off...you might as well make it real easy and cut it all off) I can do the swap myself in about 4 hours now. The clutch, plate and T.O. bearing come in the motorsport kit...you should get an alignment tool($5)....and do the rear main seal while your in there...(takes about 10 minutes only) you will need the pilot bearing though...i never replaced mine, but think it just pops out. The summit adj. cable looks identical to the rest for around $79. Good luck................. ------------------ 4.10's,long tubes & 75 shot...Goes 12.50's Check it out at http://www.burnouts.webprovider.com 11's coming soon!!!! Heads,intake and cam are all here