Problem with timing for a 302 HO.

QuantumMotorsports · 04-15-2001, 09:58 PM

To get the timing close, turn the crank by hand with a wrench on the crank end bolt until the timing mark is right on the arrow for correct timing. Take the distributor cap off and look to see where the rotor is pointing. With the timing mark in the correct location the rotor should be pointing either straight at the #1 cylinders point or 180 degrees from the #1 cylinders point(on a four cycle engine the piston hits TDC (top dead center) twice in it's cycle, once when it is pushing exhaust out and about to take air in, and once when firing. Make sure it is at one of these two places and try and crank it over. If it won't start, pull the distributor out and rotate the rotor 180 degrees and slide the distributor back in. Try again. Be very careful while doing this and if you're not very experienced you might want to find someone who can help. Good luck.

------------------
Michael Black
Quantum Motorsports
Norman, Oklahoma

1988 Merc Cougar 5.0 HO, Ported and Polished E7TEs, 2.25" duals w/ 2 chamber flowmasters, T5 tranny
New E/T!!!
14.626 @ 94.94mph, 2.194 60' time, a little better than last time. Keep in mind this thang is heavy (3590lbs) Finally 14s!!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Timing Problem at WOT	Cody2552	Windsor Power	21	11-20-2002 04:13 PM
Timing problem 87 GT	BOW TIE SMASHER	Windsor Power	4	10-21-2002 08:05 AM
Timing question...maybe problem	BoveK	Windsor Power	3	11-20-2001 07:36 PM
timing chain or timing gear	mustang66teen	Classic Mustangs	11	06-18-2001 08:44 PM
AAAARGH! Steeda timing adjuster causing computer problems!!!	bark3rd	Modular Madness	1	06-04-2001 08:15 PM

04-15-2001, 09:58 PM	#1
QuantumMotorsports Registered Member Join Date: Jul 2000 Location: Norman, Oklahoma, USA Posts: 597	To get the timing close, turn the crank by hand with a wrench on the crank end bolt until the timing mark is right on the arrow for correct timing. Take the distributor cap off and look to see where the rotor is pointing. With the timing mark in the correct location the rotor should be pointing either straight at the #1 cylinders point or 180 degrees from the #1 cylinders point(on a four cycle engine the piston hits TDC (top dead center) twice in it's cycle, once when it is pushing exhaust out and about to take air in, and once when firing. Make sure it is at one of these two places and try and crank it over. If it won't start, pull the distributor out and rotate the rotor 180 degrees and slide the distributor back in. Try again. Be very careful while doing this and if you're not very experienced you might want to find someone who can help. Good luck. ------------------ Michael Black Quantum Motorsports Norman, Oklahoma 1988 Merc Cougar 5.0 HO, Ported and Polished E7TEs, 2.25" duals w/ 2 chamber flowmasters, T5 tranny New E/T!!! 14.626 @ 94.94mph, 2.194 60' time, a little better than last time. Keep in mind this thang is heavy (3590lbs) Finally 14s!!!!