Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-26-2001, 02:46 AM
|
#8 |
|
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
If you're lucky the shop can do a radius valve job. It's just a slight step above a 5 angle job. Plus getting them poted, polished, bowl blended, and milled. Just remember milling might require rocker arm shims.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stock heads!?! | whitepony | Windsor Power | 6 | 04-08-2003 08:15 AM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| GT-40 heads, what years stock? | 7000rpmisheaven | Windsor Power | 1 | 02-21-2002 12:50 PM |
| 1.7 Roller Rockers, Hand Porting Exhaust Side Of Stock Heads... Good Idea??? | BowTie Eater 5 Liter | Windsor Power | 12 | 09-15-2001 02:00 PM |
| put heads on, or keep it stock | WADS56 | Windsor Power | 5 | 02-15-2001 06:01 PM |