Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-16-2002, 03:41 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Nebraska
Posts: 86
|
spout
the spout connector is on the same wiring harness as the connection for the distributor, it's located about 5 inches back from the main dist. connection. it is a small plastic plug that must be removed when setting base timing. I would guess 14 is plenty, However I wouldn't go much more than that though.
__________________
Proud RHC member #99 1990 Mustang GT Trick Flow heads,F303,Mac cold air,FMS 65mm tb,73mm ma,FMS 1.6,GT-40 intake,MSD igintion,NOS Big Shot@150,Mac equal shorties,Mac h-pipe,American Thunder flows,Centerforce dual friction,TTC 3550,alm drive shaft, 3.73's, HPM subframes, k-member brace, strut tower brace.. amongst others. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |
| nos & timing controller | todd5litre | Windsor Power | 5 | 01-09-2001 08:24 PM |