Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-25-2002, 02:10 PM
|
#2 |
|
Mustang Enthusiast
Join Date: Mar 2002
Posts: 528
|
gaskets
Replacing the valve cover gaskets is simple, I just replaced mine last weekend. Just take the valve covers off, take off the old gasket, (scrape any old RTV or any old gasket off if there's any on the valve covers) put some RTV on it and bolt it back up. I think you are supposed to torque the bolts to 7/12 to 10 lbs. The rear main seal is going to require you to actually drop the tranny. I would assume if Ford is replacing the clutch, they will replace the rear main seal at the same time. I hope this is what you were looking for. -Keith
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Painted valve covers | surfbeast | Modular Madness | 3 | 04-23-2003 08:19 PM |
| Valve Covers | NotchJohnson | Windsor Power | 20 | 10-17-2002 12:01 PM |
| tfs intake, tfs valve covers, NOTHING FITS | 93GTDIN | Windsor Power | 9 | 07-01-2002 12:22 PM |
| Valve covers | rbatson | Windsor Power | 8 | 06-10-2002 11:56 PM |
| Ford Racing valve covers | 2FastLX | Windsor Power | 2 | 06-19-2001 04:14 PM |