Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-25-2002, 11:54 PM
|
#2 |
|
Registered Member
Join Date: Nov 2001
Location: Northern Kentucky
Posts: 49
|
Ryan, I have a 90 coupe with H&R race springs and tokico 5 ways. Also have the MM C/C plates-nice pieces. I bought the offset rack bushings but my alignment guy, who I know well and trust, said that i didn't need them and that everythig adjusted fine. If i can remember correctly the instructions recomend putting as much caster equally as possible to make the car drive better especially around corners. Anyone correct me if i'm wrong. Check my pic in users rides under coupes. Sits a little high for me, bad picture too, good luck. Mike
__________________
90 coupe, Cobra brakes, 17x9 cobras MM lowers, SVO uppers, 3.73s, BBK 1 3/4 full lengths, H pipe, flows, subframes, H&R springs, Tokico 5-ways, Pro 5.0. Subframes, K&N, Strut brace, CC plates,83K miles, New Paint.....FOR SALE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| Did MM send me the wrong H&R SuperSport Springs for my '98 GT 'vert? | GaryDawg | Modular Madness | 2 | 08-05-2002 02:03 PM |
| H&R springs or Eibach?? (replaing my Jamex Springs) | KB94GT | Modular Madness | 0 | 05-14-2002 07:44 PM |
| Fox bodies with H&R supersport springs | RB92GT | Windsor Power | 0 | 04-24-2002 10:36 PM |
| Springs | MDM | Windsor Power | 0 | 04-11-2001 06:53 PM |