Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-30-2002, 09:08 AM
|
#7 |
|
DURKA DURKA!!
Join Date: Sep 1997
Location: Lubbock, TX...(TX panhandle)
Posts: 1,418
|
Mach,
Yeah, they give you a graphic with the drilling location. It's on the passenger forward side of the valve works. You drill straight up into the case and feed the wire through. If you wanted to do it right like they do in their trannies, Lentech will tell you to tap the hole to fit an NPT fitting and run the wire through that and seal the fitting with epoxy. If you do it the cheap way like I did, you have to knot the wire inside the tranny case, and epoxy the knot against the case. As you can tell, it didn't work too well the first time. I don't guess I let the epoxy cure long enough. --nathan
__________________
'91 GT, Coast 347, 9.5:1 compression, full intake, Wolverine 1087 cam, exhaust, Keith Craft ported Windsor Jr. Irons (235 cfm intake, 195 cfm exhaust), AOD, PI 3500 converter, Lentech valve body, 3.73's (4.10's in the works), and Yokohama ES100's out back. Daily Car: '04 Infiniti G35 Sedan 6MT |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone running a C-4 tranny I need HELP!!!!!!!! | mattcstang | Racer's Club House | 5 | 09-07-2006 11:43 PM |
| Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
| Tally-Ho the Lentech VB is in | Mopar1 | Windsor Power | 6 | 07-24-2002 01:59 PM |
| Made the decision....Going with the Lentech!! | Stang_ROTY | Windsor Power | 23 | 06-16-2002 10:53 AM |
| This is bad! Did my Uncle cause my Racing tranny to overheat?(It's a long 1... sorry) | Stang_ROTY | Windsor Power | 1 | 08-30-2001 10:55 PM |