Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-01-2001, 08:50 AM
|
#2 |
|
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
It's very important to soak the friction plates in friction modifier for at least 15 minutes, but 2 hours would be better.
There's a special tool for checking to see what size shims to use, but you can probably just put in the biggest shims and try to rotate them into the carrier housing. If they don't go, drop to the next biggest size. Mine went in with the biggest shims. Gear oil really stinks.  ------------------ 351W 89 Mustang GT Convertible |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
| 8" traction....what's out there? | 66fastback | Classic Mustangs | 5 | 10-14-2002 12:14 PM |
| TRANS rebuild kits for 5spd | drtbiker | Windsor Power | 3 | 08-18-2002 04:25 PM |
| Low cost rebuild. | salcmc | Classic Mustangs | 3 | 09-11-2001 09:16 PM |