Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-06-2002, 02:21 PM
|
#1 |
|
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
well I did not get to run it at the track But I will get it Dyno too soon I am going to setup a time this week to tell you the truth I dont know what Fuel i have it set it... I have a fuel Gauge But I have to hook it up and take it off I should get one,,,,,, so I drove the cra hard and started addjusting it tell I got to where it runs good now then I set the timming to 16-17. Runs Ok I am running 93 Gas in it I am going to try some Octan Boster in it I think it Might need it......
I have done a few G-tech Passes with teh wieght at 3550 that what I was I did 14.3@105mph with bad wheel spin.....I need new tires some BFG might help it out a bitI think I should trap about 107-108 with out to much Work the car is 2940Lbs with a 1/2 tank of gas.
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| driveshaft safety loop install? | Simi Stang | Windsor Power | 16 | 02-12-2003 07:45 PM |
| Going To Make A Driveshaft Safty Loop... Need Measurements Please | BowTie Eater 5 Liter | Windsor Power | 2 | 01-29-2002 11:08 AM |
| HELP Quick w/ HPM Driveshaft Loop Install ??? | jmeiers | Modular Madness | 1 | 06-30-2000 06:16 PM |
| Anybody install a driveshaft loop on a early Mustang! | 67enthusiast | Classic Mustangs | 1 | 03-18-2000 11:33 AM |