Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-13-2002, 01:37 AM
|
#4 |
|
Registered Member
Join Date: Feb 2002
Location: Diamond Bar
Posts: 258
|
ok i got the lower control arm off and put the new bushing in and made sure everything was right. alother problem iv had before this was that if you look at the front of the car on level ground you can see the passenger side lowercontrol arm is almost horizontal where is should be and everything on that side looks right but on the drivers side i can see it hangs down more and the drivers side sits up higher. im sure the springs and shocks are good but i was wondering what would cause this. if i push or pull up on the car i can get it to go through its range of motion and everything seems ok but it just sits too high. any ideas what would cause this? i thought maybe something is sticking not allowing it to be able to set all the way down. but that dosnt seem to be it. anything i can adjust to make it sit better? thanks
__________________
66 mustang-292-Holley 4160-World Castings Windsor Sr.-Hooker super comp headers-MSD box & Coil.3.55 gears. B&M Z-Gate-Black leather racing seats with 4pt harnes. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower control arms....what to get? | 84LX89GT | Windsor Power | 24 | 02-28-2017 06:53 PM |
| Lower control arm bushing | jwhite1993 | Windsor Power | 9 | 11-14-2003 09:38 AM |
| lower control arms | jinx6570 | Modular Madness | 4 | 03-07-2003 03:06 AM |
| granatelli lower control arms are junk! | sn95gt19 | Windsor Power | 9 | 07-02-2002 09:37 AM |
| REAR UPPER AND LOWER CONTROL ARMS | bcinyuz | Windsor Power | 1 | 05-08-2001 04:17 AM |