

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: May 2001
Location: Harrisburg, Pennsylvania
Posts: 379
|
![]() ok.....this is the same noise i hear from mine and i've heard it on many other mustangs ......same exact noise and symptoms
....not a big problem .......on mine i put a new throw out bearing and an adjustable quatrant in it ........heard this squeeking noise after putting a few miles on it.......at first i was concerned......now that i have over twenty thousand miles on it with no problems ......no concearn any more ..........since then i've heard a few other stangs with the same exact symptoms and never seen it caus a problem the culprit....the throw out bearing ......the cause .....if your clutch is adjusted so that there is no tension on the cable when the clutch is disengaged (the way it supposed to be) what happens is the throw out bearing slows down or stops turning but is still next to the forks on the pressure plate .......the noise comes when the forks on the pressure plate are baerly rubbing against the throw out bearing ....not enought to keep it turning but just enough to rub it and make an irritating noise easy cure .....go to the hardware store, get a cheap low tension spring (a screen door spring works).......install it on the linkage at the transmission so it puts a small amount of tension on the clutch lever pulling it just a scoosh away from the clutch ........if its a low tension spring it won't make the clutch harder to engage but it'll keep the throw out bearing from touching the forks on the pressure plate or if your lazy like me .....just turn the radio up ![]()
__________________
the "not so old",old guy 87 Mustang GT T-top >hanlon t-5, pro 5.0, centerforce clutch ,adj. cable/quatrant ,3.27s ,full 2 1/2 ex(off road H) adj. reg. ,e-cam ,70mm TB, cobra intake ,1.7rr ,ported/milled e7ets w/crane springs ,306 balaced/decked short block w/speed pro forged flat top pistons ...257rwhp/302rwt best et 13.7@102 (4/11 ) '80 Capri (future project,currently collecting parts for 351 moter) |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Is this a good price for a 99-02 Aftermarket hood? | steedamustang01 | Modular Madness | 0 | 08-06-2002 12:07 PM |
1999-2003 Cobra R SVO Hood Painted For Sale, What's a good price? | steedamustang01 | Modular Madness | 0 | 07-15-2002 11:05 AM |
How Much Should I Sell My Cobra R Svo Hood For? | steedamustang01 | Modular Madness | 2 | 06-25-2002 03:41 AM |
2001 Gt (steeda) Hood Update. | steedamustang01 | Modular Madness | 4 | 04-30-2002 06:16 PM |
My Review on Motion Performance Parts Hoods | Fox Body | Blue Oval Lounge | 8 | 11-22-2001 05:10 PM |