Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-15-2002, 06:05 AM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Location: Mansfield, OH.
Posts: 113
|
This is how I matched every thing up. Take 4 pieces of 5/16" allthred to bolt in heads at each corner. Take gasket and place them on heads to see how well they line up. Trim as needed. Then take a few drops of silicone on intake side of gasket still in place and put intake on. Wait for silicone to dry and pull off intake and mark gasket. This will give you as close a match as I could figure how to do. Hope this helps.
__________________
Amsoil, The finest in synthetics T-1 certified Amsoil dealer Oils,Lubes,Filters www.lubedealer.com/midohio |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| GT-40 lower intake question (small ports) | Dark_5.0 | Windsor Power | 1 | 01-28-2002 08:07 PM |
| SystemaxII intake and Box stock RPM heads | NewAge 5.0 | Windsor Power | 4 | 01-18-2002 12:52 AM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |