Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-17-2002, 09:07 PM
|
#4 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
one other thing, they don't work out of the box, you need to do a "bedding in" process. Its is just a heat cycle to remove a layer of oils on the surface, its explained in the instrucions in the box. So if you are racing, bedd in a few sets of pads before you race so you can change them and have them work right away. Mine were smoking after I did it, now they work perfectly.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| installed pa performance alt | GhettoPop | Windsor Power | 1 | 04-11-2004 09:42 PM |
| CAI Installed Whew!?! | mustardjohn | Small Ponies | 0 | 11-08-2003 05:32 PM |
| Eibach Springs Installed | COUSIN ROB | Modular Madness | 0 | 05-13-2003 09:17 AM |
| Replacing Brake Pads on 96 F150 | jimberg | Built Ford Tough | 2 | 08-26-2002 04:01 PM |
| Getting Novi 1000 installed Wed. | Chris_H | Windsor Power | 3 | 12-31-2001 07:22 PM |