Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-17-2001, 10:20 AM
|
#4 |
|
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
Mach 1 is absolutely right. Just set it to .98 and don't worry about it. There're only three things the ECM is looking for, closed throttle, part throttle, and WOT.
If you set it too high, your ECM may think you're at part throttle when you're really at closed throttle. That's not good. The only time you should really check it is after setting idle. If you're idling high, you need to do something else to set your idle. Search on feeler gauge idle to find threads on the subject. ------------------ 351W 89 Mustang GT Convertible |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about sensors and voltage | MustangGT1990 | Windsor Power | 6 | 02-06-2003 02:55 PM |
| AMPS or Voltage? | Godslayer | Windsor Power | 4 | 08-02-2002 10:55 AM |
| Fuel pump voltage | greydan | Windsor Power | 3 | 01-26-2002 10:02 PM |
| Autometer gauge problem - Always reads oil pressure... | 88COBRA | Windsor Power | 0 | 09-06-2001 06:44 PM |
| battery voltage and temp guage ?? | withamc | Windsor Power | 1 | 02-22-2001 04:52 AM |