Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-24-2001, 12:33 AM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: Thousand Oaks, CA
Posts: 396
|
OK - got answers on the bezel and painting the needles. They should pry right off, right? How about some help figuring out where the things should point? Voltmeter is easy. I figured I can throw the temp sensor in a pan of boiling water and measure the resistance, that should be 212*, then just put a resistor of the same value to ground and set the needle to 212. Any ideas on the oil pressure guage?
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bbk White face guage backlight problem | skiwesser | Windsor Power | 5 | 05-27-2003 06:52 AM |
| White face gauge question. Not which one to get either | Silver GT 01 | Modular Madness | 6 | 03-27-2002 08:11 AM |
| White Face Gauge install tips | DemonGT | Windsor Power | 3 | 04-11-2001 12:25 AM |
| MAC white face gauge install - I screwed up | 2FastLX | Windsor Power | 2 | 03-26-2001 12:12 PM |
| White Face Gauge Install Questions | stangsrule | Windsor Power | 4 | 03-24-2001 09:41 AM |