Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 03:02 AM
|
#2 |
|
Registered Member
Join Date: Mar 2002
Location: Arizona
Posts: 172
|
Ok, I will try to explain this the best I can, but I am no expert, so if I am wrong, someone correct me.
 Shorty Headers will give you more top end power, and are a lot easier to install. Long tube headers are a pain in the you know what to install, but supposedly can give you more power as you do more mods later on. If I was you, I would go with the shorty headers as they are easier to install, and probably alot cheaper than long tube headers. Just be sure that the Jet Coating on the headers is good quality, so that it will not get warped from the heat. Some good header manufacturers to check out are JBA Headers, and BBK. Hope I was able to help you out.
__________________
91 Mustang LX 5.0 Convertible AOD Mdifications: K&N filter, Mac Catback, BBK aluminum u/d pulleys. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SVO Shorty Headers 1-5/8 Question | stangposse | Windsor Power | 0 | 08-07-2003 12:48 PM |
| Buying new headers | TwiLighTBluEGT | Windsor Power | 4 | 04-23-2003 08:55 PM |
| Anyone have problems with MAC headers?? | HiFlow5 0 | Windsor Power | 15 | 05-30-2002 08:30 AM |
| Headers should I or shouldn't I....Need Advice Quick Please | Mustang_GT_90 | Windsor Power | 9 | 05-01-2002 01:16 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |