Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-10-2002, 11:18 PM
|
#17 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
It doesn't look good. You have one more test to do to confirm your suspicions. You need to disconnect the 60 pin connector from the ECM. Then, take a DMM set to DC volts, on the 20 scale, connect the pos. test lead to the pin at wire 1 in the connector. Pin 1 will be one of the corner pins, with a Black/Orange wire going to it. Then connect the neg. test lead to pin 40 or pin 60 (pin 60 is the exact opposite corner from where the 1 pin is, and pin 40 is below it (see attached pic). Turn the key on (KOEO), and read the DMM. If the reading is less than 10.5vdc, there is an open in one of those wires, and you will need to trace and find it. If the reading is more than 10.5vdc, the ECM is bad, and must be replaced.
Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ATTN: PWRWUD and others. Fuel Issue w/Codes | 88fivepointoh | Windsor Power | 1 | 05-01-2003 11:30 PM |
| ATTN: Michiganders----Milan meet up | Tony Frank | Blue Oval Lounge | 6 | 05-28-2002 05:36 PM |
| ATTN 1995 GTS and 248a owners | hillie16 | Blue Oval Lounge | 5 | 03-11-2002 10:52 PM |
| Attn. CA people!... | Rally | Modular Madness | 3 | 03-08-2002 04:35 AM |
| attn 2fastlx-urgent | Crazy Horse GT | Blue Oval Lounge | 0 | 01-03-2002 12:46 PM |