Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-12-2002, 07:43 PM
|
#8 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
steedamustang01 - As far as I recall that was all that was required for the install. The MM ones came with good instructions. If you want to PM me a fax number I can probably dig them up and send them to you from my office. You just want to be careful when drilling the 4th hole and make sure it is in the right place. Also, the plates on the MM ones can be flipped over to offer two different ranges of negative camber adjustment, so you just need to make sure you have them on the right way; the instructions explain this as well.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help woth installing groundpounder coilovers with BBK caster camber plates | ciara | Windsor Power | 0 | 01-10-2004 01:08 PM |
| Caster camber plates ? | COUSIN ROB | Modular Madness | 6 | 04-30-2003 05:28 PM |
| Always need caster camber plates? | squid | Windsor Power | 3 | 03-23-2003 11:52 PM |
| Steeda vs MM Caster Camber Plates | Mustangbelle306 | Corner Carvers Delight | 4 | 02-25-2002 05:47 PM |
| do i need camber caster plates | chatcher | Windsor Power | 5 | 11-04-2001 01:01 PM |