
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
|
|
#1 |
|
Registered Member
Join Date: Sep 2002
Location: NYC
Posts: 245
|
Hey, everyone else pretty much covered all I was going to say. But I wiil add this, You said you wanted to have shift points up around 6500rpm. Talk to the supercharger people to much sure they can handle that RPM. With advancements in superchargers they probably can. But, as far as I can remember the older ones lost effiency up around 6000rpm mostly due to heat, so you might want to think about an intercooler. Oh and think about how your going to put all that power to the ground. Sub frame connectore and a good ladder bar or 4-link. What kind of tires are you running. If you get good traction the front is going to get air son be careful at first. If you dont launch strait, it will be hard to steer with you front off the ground!!
|
|
|
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Going overboard building my new PC? | StangFlyer | Blue Oval Lounge | 49 | 03-07-2003 03:55 PM |
| Building first engine....help | 90lxracer | Windsor Power | 3 | 11-19-2002 08:12 AM |
| The Bottom End | HuKares | Windsor Power | 2 | 10-14-2002 09:55 AM |
| Repairing the Rust on the bottom lip of my hatch. Any tips or Suggestions???? | MTU 50 | Windsor Power | 12 | 03-15-2002 02:12 PM |
| Building a 351w, advice | dinomite | Windsor Power | 1 | 02-06-2001 03:20 AM |
