Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-20-2002, 03:21 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Make sure you check the specs on your cam to see if you can run 1.7 rr's. Getting 1.7's is almost the same thing as getting a bigger cam. It holds the valves open longer and farther. If you run a larger cam with larger ratio rocker arms, you may push the valves to far and slam them into your pistons.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power for the Power Amp | traderguy | Audio, Security, & Electronics | 2 | 07-13-2003 08:07 PM |
| Lost top end power | bobtodd | Windsor Power | 11 | 08-01-2002 10:28 PM |
| Power WIndow ?'s | Coupe Devil | Windsor Power | 5 | 10-23-2001 03:12 PM |
| power shift? | JamGtStang | Windsor Power | 6 | 03-01-2001 02:11 PM |
| Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |