Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-21-2001, 04:25 AM
|
#4 |
|
Registered Member
Join Date: Apr 2000
Location: New Jersey
Posts: 167
|
Here's my situation. I have a set of 93 Cobra wheels. I just bought a complete rear out of a 93 Cobra. I was told that all I needed to do upfront, was to switch to the 93 cobra front rotors. Just out of curiosity, I checked to see if the same front calipers where used on the 93 GT and 93 Cobra. The part numbers matched. Then I checked the 89 front calipers on a GT (because this is the car I have) and it was a different part #. I called the Ford Tech Line in the Motorsports catalog and they told me it didn't matter that the caliper might be different, because ANY rotor from 87-93 will fit ANY Mustang.
[This message has been edited by RMARIANI (edited 06-21-2001).] |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front end feels a little "loose" | Simi Stang | Windsor Power | 4 | 04-29-2004 08:23 AM |
| Front End: Repair or Replace | ttremblay | Blue Oval Lounge | 3 | 01-31-2001 10:18 PM |
| Need new front tires... suggestions... | FivepointOH | Windsor Power | 4 | 01-01-2001 11:20 PM |
| Steel vs. rubber bushings for front calipers | Jason Van Holland | Corner Carvers Delight | 2 | 06-01-2000 03:02 PM |