Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-01-2002, 11:22 AM
|
#6 |
|
Registered Member
Join Date: May 2002
Location: IL
Posts: 32
|
Here is my stock numbers (Left):
The biggest gains that I got was probably from the x pipe & the catback not sure on the numbers. I don't have any picture of the tires but they hang over the wheel about an inch, not the best tire for drag racing. If you still have the IRS I would be very careful of halfshaft breakage with the D/R. Good Luck, Tim
__________________
1999 Mustang Cobra Solid Axle w/ 4.56's Magnaflow Cat-Back Dr.Gas O/R X-Pipe JBA 1-5/8ths Shorty Headers Homemade Powerpipe March Pulleys JMS Chip Steeda Tri-Ax Shifter Best E.T. w/ parts listed & BFG 275/40/17 D/Rs (10-26-'02; not including JMS Chip)- 12.95 @106.82, 1.79 60FT. Best MPH- 107.43 New Best MPH (4-26-03)- 109.45 316 RWHP/ 309 RWTQ Last edited by Tim Lester; 12-02-2002 at 10:29 AM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 331 Dyno results | 302 LX Eric | Windsor Power | 12 | 04-29-2004 10:13 PM |
| Dyno results | 7up | Windsor Power | 3 | 08-12-2002 01:24 AM |
| DYNO results, and questions | mmike | Windsor Power | 7 | 09-24-2001 09:11 PM |
| Dyno results inside with timing adjuster installed | Mustang92 | Modular Madness | 7 | 02-20-2001 09:24 PM |