Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-08-2002, 11:58 AM
|
#2 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
You need to check your fuel pressure and check for spark. Is it possible that you ran over something that might have tripped your inertia switch?
Try to start it, but don't touch the gas pedal. Then pull a spark plug and see if it's wet. If it is, dry it off, and stick the wire back on it, and set it so that it is in contact with the block. Crank it over and look for a spark. In short, it takes 4 things for an engine to run: air gas ignition compression You are lacking one of those things. We just need to figure out which one. Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|