Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-13-2002, 09:18 AM
|
#4 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
You'll need the bumper cover (duh) headlights (duh) headlight wiring (the plugs are different)
and I know on the 84 that TRM (my school's motorsports club) is buildiing, they bumper support is steel and much heavier than the fiberglas one in the 87-up, so you may wanna change that too if you are concerned about weight. But the steel one should work fine if not. You didn't get yet ANOTEHR stang did ya Josh? TransAm86, is that you in your avatar?
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front end feels a little "loose" | Simi Stang | Windsor Power | 4 | 04-29-2004 08:23 AM |
| Front End Wobble | orlowted | Classic Mustangs | 6 | 04-14-2004 02:23 PM |
| will sn95 convert rear seats fit in a sn93 convert??? | LX XLR8R | Windsor Power | 4 | 06-05-2001 10:22 PM |
| front bumper skin needed !! | jetuomi | Windsor Power | 1 | 05-11-2001 11:36 AM |
| Front End: Repair or Replace | ttremblay | Blue Oval Lounge | 3 | 01-31-2001 10:18 PM |