Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-01-2003, 08:51 PM
|
#2 |
|
Registered Member
Join Date: Apr 2000
Location: Collegeville, Pa, USA
Posts: 75
|
If you can swing it go with the Holley! Its huge, but then I had a cobra intake that was stock to compare it to. If you think you are going to add cubes, N02 or blower, go with the Holley.
It added alot through the RPM range for me, but I do have a blower. Good luck!
__________________
93 GT Red/Grey B50 8.5:1 block, S trim, 2.95 pulley, 6037 heads, Crane Interceptor 2, Comp XE276HR cam, BBK longtubes, Mac catback, Holley Systemax II intake, Kirban fuel regulator, Accufab 70mm t.b., 80mm Pro-M meter, 36lb. injectors, 1.7 roller rockers, FMS C springs, Factory Five upper and lower control arms, Real Ford Cobra R wheels, 3.73 gears, M2300K cobra 4 wheel disk brakes. 505rwhp/472rwtq with home tune! 2/03 5.0 Mustangs and Super Fords magazine feature car page #166 8/02 MM/FF Feature Car page #102 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Explore intake??????????? | William Bowers | Windsor Power | 2 | 02-14-2002 10:27 PM |
| HELP!!! oil in intake, what to do?? | bosco | Windsor Power | 4 | 02-03-2002 05:02 PM |
| My Tough Intake Choice | PeTr0 | Windsor Power | 9 | 06-04-2001 08:08 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |