Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-22-2003, 08:00 PM
|
#4 |
|
Registered Member
Join Date: Oct 2001
Location: Madelia,MN USA
Posts: 58
|
Excellent, I was hoping that was the case. I've been told that the studs help keep aluminum heads from warping and aids in head gasket sealing. 91GTturbo do you have your block tapped for 1/2" studs? A machine shop told me that tapping 1/2'' studs on a factory block actually weakens the deck and is overkill on a stock block. Any opinions on this?
__________________
331 stroker, JE 8.5:1 pistons, H-beam rods, steel crank, main cap, msd with 3step, BBK ceramic long tubes,TKO, 4.30's, motorsport Z303, Victor Jr aluminum heads, crane gold 1.6, southside lift bars, 90/10 front, 50/50 rear, centerforce dual friction clutch, Vortech S-trim soon. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best way to remove head studs? | Hozer 88GTConv | Windsor Power | 3 | 03-12-2004 07:59 PM |
| Head Studs | speedytang | Windsor Power | 3 | 09-17-2002 11:30 AM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| ARP Head Stud install | Prochrgd1 | Windsor Power | 7 | 03-27-2002 01:31 AM |