Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-29-2003, 03:42 PM
|
#2 |
|
Registered Member
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
|
I have heard of it being done without lifting the motor. I believe there was an article about it somewhere on the mustangworld.com website. Other than that, it should come with directions.
__________________
2000 GT 80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters, Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Long Tubes for AOD | Mustvid | Windsor Power | 4 | 09-18-2003 09:29 AM |
| will bbk long tubes fit with a c-4?...please help | dragstang86 | Windsor Power | 3 | 04-24-2003 12:49 PM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| long tubes or shortys | 5ohCOUPE | Windsor Power | 7 | 11-14-2001 09:19 AM |
| 1 3/4 Hooker Long Tubes vs Shorties results! | 8850 | Windsor Power | 2 | 02-04-2001 12:42 AM |