Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-15-2003, 03:57 PM
|
#4 |
|
Registered Member
Join Date: Feb 2003
Location: Seattle, Wa.
Posts: 175
|
Stock pipe diameter is 2-1/4" offically. But it does get down to about 2" in diameter when it goes up and over the rear end. At least it was when measured with calipers on a 01 Bullitt.
EEC (electronic engine control) the IV means 4th generation. EGO (exhaust gas oxygen) sensor. tells the computer how much oxygen is left in the exhaust and based off of that info the computer can tell if the engine is rich or lean and shortens or lenghtens the pulse width of the fuel injector to compensate. A good MIL kit is just a simple plug in and can be done with little problem. The computer (ECU) (electronic control unit) (PCM) (powertrain control module) takes readings and makes adjustments several hundered times a second. Sounds like (pun intended) your going to a lot of trouble over a little (or lot) of noise.
__________________
No matter how much you spend, or how much you prepare, there is ALWAYS someone else faster or quicker than YOU!!!!!!!!!! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| h pipe or x pipe, and which ones | apowers2k | Modular Madness | 3 | 02-10-2003 12:09 PM |
| bbk unequals and stock H pipe :( | scale | Windsor Power | 4 | 06-14-2002 11:41 AM |
| Off road pipe vs. Catalitic Pipe | Kamaro Killer | Windsor Power | 7 | 04-04-2002 04:05 AM |
| Mac H pipe w cats vs BBK x pipe with cats?? | Chevyguy | Windsor Power | 15 | 11-16-2001 08:34 AM |
| Flowmaster Pipe Diameter | King Snake | Modular Madness | 4 | 09-05-2000 05:29 PM |