Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-06-2003, 07:10 AM
|
#4 |
|
Registered Member
Join Date: Feb 2003
Location: NJ
Posts: 81
|
First get a screw driver and connect both bolts of the seloniod together and if the starter turns over then it is your probably your seloniod, whats happeneing is it is not letting the connection go to the starter, it only cost about 10 bucks.
Ernie
__________________
93 GT 351 to 393 stroker, GT40 upper and lower intake, GT40X Turbo Swirl heads, holley 80mm throttle body, 255 fuel pump, 42 lb injector, JE pistons, Comp cam, comp lifters, comp pushrods, comp springs, crane Roller rockers. Trick flow Crank Shaft, comp Timing chain. MSD 7 series ignition, msd hvc2 coil, MSD timing adjust, MSD Pro billet Dis, Hooker long tube, Off road H pipe 1 chanber race flows, 4.10 gears, Vortech cooler and T-Trim with a 25lb boost AND LOTS MORE. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starter problem....still there | Hethj7 | Windsor Power | 18 | 07-23-2006 05:17 PM |
| identify the wires to starter solenoid | Bad89stang | Windsor Power | 13 | 04-24-2003 08:57 PM |
| Help!! Starter problem. | DRASTiK | Windsor Power | 2 | 04-07-2002 03:51 PM |
| Starter problem? | Just me | Windsor Power | 8 | 01-06-2002 10:40 PM |
| Starter Solenoid problems? | fastsvo | Classic Mustangs | 1 | 08-22-1999 08:30 AM |