Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-26-2001, 03:20 PM
|
#2 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
I had the same problem. You need to take off the covers and machine the inside under where the oil sprout it. Make sure that you have the "correct" set of covers also.
------------------ Finally DONE!! 93 GT, 393 stroker w/ Edlebrock Performer heads and EFI, 30lb injectors, Dynamic Roller Mite C4, 8 pt cage, Sothside Machine bars & Sub-frames, 3.73's, '69 351W block w/SCAT crank. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will 1.7 roller tip rockers clear stock valve covers. | Dark_5.0 | Windsor Power | 3 | 02-07-2002 05:45 PM |
| pre-86 cast valve covers and Roller Rockers | matt cook | Windsor Power | 6 | 01-26-2002 06:16 PM |
| double valve spring?? roller rockers???? | jerryIII | Windsor Power | 1 | 07-13-2001 04:36 PM |
| Roller Rockers And Stock Valve Covers | PMDFoxbody5.0 | Blue Oval Lounge | 3 | 06-07-2001 12:44 AM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |