Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-29-2003, 03:10 PM
|
#9 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
Yeah those look to be the ones. You can tell by the drivers side one, because teh steering shaft goes between 2 of the primaries. That part is a bit of a hassle on the install, but since the motor is out, you won't have one bit of a problem putting them in.
I did mine with the motor in the car. Had to jack the engine up to get the passenger side header in, and remove the steering shaft to do the drivers side. Other than that, they weren't too bad. good luck
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Header Question | Jamie_DTR | Windsor Power | 6 | 04-17-2003 07:58 AM |
| Header question | bigred90gt | Windsor Power | 4 | 03-24-2003 12:38 AM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Header question | tomcat_37096 | Windsor Power | 3 | 10-08-2001 05:14 PM |