Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2001, 07:51 PM
|
#2 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Damn, that sucks....well I hate to say it but you can try to re-tap it if there is enough threads to grab, but if that doesn't work I would think you would have to enlarge it to the next size bolt and then tap it, you would also have to enlarge the holes on the pulley, do all 4 if it comes to that, sorry that's the only thing I can think of.
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Urgent.....read This!!! | Kevin Price | Blue Oval Lounge | 15 | 02-05-2003 01:11 PM |
| URGENT Suggestions on Bearings & Rings | jim_howard_pdx | Windsor Power | 3 | 09-24-2002 09:12 PM |
| MAC Pullies OK, or would you recommend another? (a little on the urgent side) | 95mustanggt | Windsor Power | 3 | 05-24-2002 10:05 AM |
| URGENT!! Senate Bill S1766 to call for scrapping of cars 15 years or older | 89FHPLX | Blue Oval Lounge | 13 | 02-09-2002 07:06 PM |
| Just Got gear installed!!!! Urgent | JamGtStang | Windsor Power | 9 | 04-17-2001 08:50 AM |