Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-02-2003, 02:10 PM
|
#1 |
|
Registered Member
Join Date: May 2003
Location: So Cal.
Posts: 14
|
Rocker stud removal.
Since the correct tool to do this will cost you more than the shop charges, I'd let them do it. However, if you want to try the cheap way out, after removing heads and rockers, stack washers over a stud, apply a little grease to top washer, put nut on stud. Tighten nut to pull stud. You'll have to add washers 2 or 3 times on each stud. If you have "bottle neck" studs, and break the tops off, you are hozed and the shop should/will charge more.
__________________
Some people can break a cannon ball, in a sandbox, with their bare hands. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker arm stud removal | sleeperstang | Classic Mustangs | 8 | 08-05-2003 12:45 PM |
| adjusting valves/ stud mount?? PKRWUD? Anyone?? | Simi Stang | Windsor Power | 8 | 07-08-2003 11:43 AM |
| TFS TW rocker stud Q | drudis | Windsor Power | 0 | 01-22-2002 02:37 PM |
| Adjustable roller rocker problems | Greystang302 | Windsor Power | 0 | 05-14-2001 01:57 PM |
| stud mount rocker install | Blown 306 | Windsor Power | 2 | 05-13-2001 10:25 AM |