Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-21-2003, 05:24 AM
|
#1 |
|
Registered Member
Join Date: Oct 2002
Location: Fresno, CA
Posts: 101
|
DON'T PLUG UP THE HOLE ON THE VALVE COVER!!! This is what relieves your engine of all the blow-by vapors. You can go buy a universal fit one at AutoZone or Kragen for $8 or so. It has a rubber base and will slide over the plastic piece in the valve cover. The breather filter will not hurt anything, air flows through it only at cruising speed where vaccum is around 10" HG. Under load or at idle the PCV valve is closed. I've had the breather cap on mine for a while now, and no problems. The MAF senses air after the breather inlet. Just don't disconnect it from the passenger side of the engine where it goes into the intake manifold.
__________________
 _________________________________ 04 Cobra densecharger CAI BBK off road X pipe Custom Electronic Exhaust cut outs Tuning via Diablo Predator Ported and polished Throttle body and plenum Line locker (for the smoke shows) Stock boost 412 rwhp 379 rwtq |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Valve cover question | Stang951 | Windsor Power | 1 | 03-27-2004 11:57 PM |
| Need tall valve covers + breather tube | Hozer 88GTConv | Windsor Power | 0 | 01-31-2004 10:58 AM |
| valve cover to TB hose?? | Simi Stang | Windsor Power | 11 | 12-22-2003 02:12 AM |
| A Valve Cover Story (long but gimme some pointers here) | Super_Stang | Windsor Power | 1 | 08-12-2001 07:29 AM |
| Valve cover breather and oil? | rbatson | Windsor Power | 5 | 03-20-2001 11:38 PM |