Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-08-2003, 12:48 PM
|
#7 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
Look man, get a momentary single pole single throw (SPST) normally open switch from like Radio shack or Autozone or some place like that. Run a wire from somewhere either in the fuse panel or on the battery that is always hot, or run one that is only on when the ignition is on, to one node on the switch, then run the other one to the starter solenoid where the wire from the steering column goes to it. It's that simple. Why would you want a starter switch anyway unless you were completely getting rid of your ignition cylinder?
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Starter problem....still there | Hethj7 | Windsor Power | 18 | 07-23-2006 05:17 PM |
| Quick Starter Install Question | Evil Joe | Windsor Power | 3 | 09-16-2003 08:50 PM |
| Putting in clutch pedal after starter install now produces very high pitched whine | crazypete | Windsor Power | 3 | 08-18-2003 08:51 PM |
| Starter won't engage on T5 to C4 install. | mikew88gt | Windsor Power | 14 | 05-27-2003 01:22 PM |
| Help!! Starter problem. | DRASTiK | Windsor Power | 2 | 04-07-2002 03:51 PM |