Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-30-2004, 10:47 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
The best "basic" subframe connectors on the market are the full-length versions from Maximum Motorsports. Any of the "bolt on" connectors are useless. The only way to make them effective is to weld them in.
If you have good fabrication skills, you can install real subframe connectors, which will run through the floor and literally connect your two subframes and also give a good foundation to install a cage. I am in the process of installing a WC setup from Griggs Racing, which also moves the lower control arm mounting points forward.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sub frame connectors, roll cage ????? | 84GT350-1 | Windsor Power | 3 | 05-11-2004 09:59 AM |
| Sub Frame Connectors | TwiLighTBluEGT | Windsor Power | 9 | 08-12-2002 09:30 AM |
| Sub Frame Connectors | TwiLighTBluEGT | Windsor Power | 6 | 06-20-2002 02:40 PM |
| sub frame connectors | mellow yellow | Windsor Power | 5 | 02-19-2001 09:53 AM |
| Frame connectors | Ember | Classic Mustangs | 1 | 06-25-2000 05:51 PM |