

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
|
Thread Tools | Rate Thread | Display Modes |
|
![]() |
#1 |
Guest
Posts: n/a
|
![]() thanks for the replies, i'll try it tonite, i've been trying to install the bell housing and trans at the same time..
the rear main seal is a bit tough to get out, but yes a screw driver works.. for the pilot bushing (if it's not the same size as needed) you may need a slide hammer, they fit really tight. ------------------ Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's..... Some day (3:73 gears & N2O)!!! will this ever end???? |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
Please Comment of Speed Secret # 2 | jim_howard_pdx | Windsor Power | 20 | 11-06-2002 11:44 AM |
Please comment on my speed secret of the day | jim_howard_pdx | Windsor Power | 20 | 11-06-2002 04:35 AM |
71 mustang auto trans not working | BIGTHOO | Classic Mustangs | 2 | 04-24-2002 06:49 PM |
1996 Cobra vs 2001 Trans Am | Milktasd | Stang Stories | 2 | 01-22-2002 09:27 PM |