Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-01-2004, 11:50 AM
|
#9 |
|
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
I agree that's not bad, I had mine bored, honed,assembled, and balanced for 1400, but it's balanced to within 1/2 of a gram. These guys are good and have a very high reputation. Keep in mind you get what you pay for too.
Good Luck
__________________
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| 65 - 66 Restoration Costs | Bossco | Classic Mustangs | 4 | 04-24-2003 04:29 AM |
| extra gear costs | Stang39r | Windsor Power | 3 | 03-31-2002 08:00 PM |
| Where can I find engine block machining specs? | 2FastLX | Windsor Power | 0 | 11-30-2001 01:34 AM |
| Machining on a stock throttle body - can it be done?? | 2FastLX | Windsor Power | 5 | 03-29-2001 10:34 AM |