Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-27-2004, 07:21 PM
|
#8 |
|
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
Re: intake manifold gasket tips
I coated the entire underside of the gasket with silicone and stuck it to the head. On the side of the gasket facing up I put a little silicone around the water ports.
I had to be very careful torquing down the intake or one side would be higher than the other and mess up the seal. If I were you I would just run a trickflow intake that will match up better with the heads. Good luck. 
__________________
92' LX-Big brakes, Lots and lots of suspension, GT40X heads, Ported cobra intake, stock cam, Vortech SC trim. 00' Lightning-Stock 88'CRX-13 second ego killer |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra intake manifold | stanger9219 | Windsor Power | 2 | 09-12-2003 07:09 AM |
| 302 Intake Manifold | btacarlton | Windsor Power | 2 | 08-31-2003 06:08 PM |
| Intake gasket woes.....any suggestions? | jim_howard_pdx | Classic Mustangs | 12 | 04-28-2002 10:19 PM |
| (Where can I/What is) a good intake manifold? | Sonics2042 | Windsor Power | 11 | 12-27-2001 05:48 PM |
| gasket matching intake ports | matt cook | Windsor Power | 3 | 12-07-2001 04:44 PM |