Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2005, 10:25 PM
|
#4 |
|
Registered Member
Join Date: Jun 2001
Location: butler pa
Posts: 303
|
Re: throwout bearing retainer?
the shaft on the unit that is on the tranny is 3 and 5/8 the new one is 3 inches other than that they look the same the new one is a ford racing steel unit instead of the aluminum one and it was $40
__________________
92lx wannabe saleen |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Throwout Bearing Blues | Rstng93 | Blue Oval Lounge | 2 | 06-19-2004 07:41 PM |
| clutch and throwout bearing questions | bmxmon | Classic Mustangs | 0 | 05-23-2004 04:32 PM |
| T5 hard to shift after replacing bearing retainer | Merlin76 | Windsor Power | 8 | 02-20-2004 10:22 PM |
| Stock steel bearing retainer? | Merlin76 | Windsor Power | 1 | 04-13-2003 08:42 AM |
| Need advice on throwout bearing | RPM427 | Windsor Power | 2 | 08-28-2002 02:05 PM |