Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-31-2005, 11:23 PM
|
#12 |
|
Registered Member
Join Date: Aug 2004
Posts: 40
|
Re: Info on 351w strokers
lol exactly what i was going to do , i have a set ( well three) that i spent 8 hours glass beadin at school when i was planning a cheap streeter motor , which i will probally do with my 79 block after the right bits show up for our boreing bar so i can put a sleeve in it at i put my 69 block .030 over , i had never seen a piston let go like the one in the 79 block though it just ripped apart right at the pin bosses and wedged the piston in a angle in the cylinder , and well round things only fit good in a round hole when they are flat i guess when you try to turn then side ways in there they do some damage who would have figured hey lol
__________________
83 capri t-top, tubular k-member,tubular control arms, coilovers, 408w, with 225cc pro cnc heads , merkl race shop c-6 trans etc shes coming together 79 burb 15.27`s at 90 mph 6800 pounds no juice do i need to say more |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need info on Edel-3880 lower EFI 351W manifold | Stang_ROTY | Windsor Power | 0 | 08-14-2004 08:40 AM |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Where to find 351W SVO | GodStang | Windsor Power | 0 | 10-11-2002 02:04 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |