Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-07-2001, 12:11 PM
|
#9 |
|
Registered Member
Join Date: May 1999
Location: norfolk,va
Posts: 265
|
Exgmguy, Thanks.
You need to get the S-trim out of the box! It's not helping you there!  I get out of the Navy in October and my family and I are moving to Battle Creek (Thats were my wife is from.) Maybe I will run into you sometime. ------------------ 95 Cobra, 9LB Powerdyne, Forged Pistons, Twisted Wedge heads, 70mm TB, Bullet 75mm Mass-air, TFS 1.7 rockers, 38lb injectors, Roller Timing Chain, Stewart Water Pump, High Flow Oil Pump, B&M Ripper, SVO HD clutch, 255lph, Full MSD system w/BTM, MAC Headers,MAC H-pipe w/cats, 3:55's,By-pass valve, Incon Check Valves,Sub-frames, Driveshaft loop, Fuel pressure regulator, flowmasters, A-pillar gauge, intake spacer. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dyno Tune?? | Gho$t | Windsor Power | 1 | 01-10-2003 08:16 AM |
| Dyno Tune in the Ohio area? | squid | Windsor Power | 2 | 01-05-2003 11:03 AM |
| What is done on a dyno Tune? | Chipdog | Windsor Power | 5 | 04-09-2002 09:12 PM |
| DYNO TUNE AND CHIP IN LOS ANGELES AREA | DAVE94LIGHTNING | Windsor Power | 4 | 10-30-2001 11:49 PM |
| Dyno tune and chip | 95snake | Windsor Power | 9 | 02-04-2001 11:44 AM |