Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2001, 11:51 PM
|
#16 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
I was told today by a guy that sells TW heads and has installed a "few" sets that the bad valve issue was probably because some dealers by the bare heads and put their own hardware in them using two piece valves that are prone to snap at the weld. He said he uses a one piece stainless valve and has had no problems with the TW heads and recommends them over the AFR's. Any other thoughts on this?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AFR or Trick Flow Heads | NitroNixon | Windsor Power | 13 | 09-02-2004 06:26 PM |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Trick Flow Manifold Install | squid | Windsor Power | 1 | 11-09-2002 06:24 PM |
| Trick Flow Specialties good guys! | 8850 | Windsor Power | 1 | 03-24-2001 11:33 AM |
| Trick Flow "R" Intake on a stock 88 5.0??? | BowTie Eater 5 Liter | Windsor Power | 3 | 01-15-2001 09:44 AM |