Dyno time

Killercanary · 03-11-2001, 08:47 PM

Remove 1 quart of oil from your motor. According to MM&FF this was worth like 10HP due to the crank not churning in the oil. 1 quart low won't hurt either. Its worth a try. I would have a new fuel filter in place, a new oil change with lightweight synthetic oil- I use 0W30 by Mobil in my street car. Its like water, but does the job. Get to the dyno early to make sure the car is cooled off. Clean your K&N. This will ensure your motor is in tip top condition. You may also want to replce the cap and rotor, check your plug wires. I don't know how to do it but if you pull the spout connector you can run total timing, and this is supposed to be worth a few ponies, but isn't good for the street.

------------------
95 GT convt' 5 speed, 3.73's,FMS HD clutch, Pro 5.0 shifter, ASP alum. underdrive pulleys, Bassani offroad X pipe, 2 chmbr flowmasters, K&N w/o silencer, edelbrock performer intake, FRPP 65mm T-body, FRPP shorty headers, FRPP aluminum driveshaft.Hooker 4pt chrome car bar, Xenon/Wings West ground effects, custom interior
Best ET: 13.83
Best MPH: 98.55mph with Best 60': 1.91 on Nitto DR's
Homepage: <A HREF="http://www.angelfire.com/pa2/killercanary" TARGET=_blank>http://www.angelfire

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
331 Dyno results	302 LX Eric	Windsor Power	12	04-29-2004 10:13 PM
crane cam dyno results are in ,kind of?	46stang	Modular Madness	5	12-04-2001 08:58 PM
Desk top dyno 2000,any body ever"check" with real dyno pull after building engine?	robertwigton	Windsor Power	8	12-01-2001 03:03 PM
DYNO TIME !	Skyman	Blue Oval Lounge	13	03-12-2001 01:12 PM
First time on slicks, pics in side!	Mustang92	Blue Oval Lounge	21	02-13-2001 12:46 AM

03-11-2001, 08:47 PM	#5
Killercanary Registered Member Join Date: Nov 1999 Location: Altoona, PA Posts: 336	Remove 1 quart of oil from your motor. According to MM&FF this was worth like 10HP due to the crank not churning in the oil. 1 quart low won't hurt either. Its worth a try. I would have a new fuel filter in place, a new oil change with lightweight synthetic oil- I use 0W30 by Mobil in my street car. Its like water, but does the job. Get to the dyno early to make sure the car is cooled off. Clean your K&N. This will ensure your motor is in tip top condition. You may also want to replce the cap and rotor, check your plug wires. I don't know how to do it but if you pull the spout connector you can run total timing, and this is supposed to be worth a few ponies, but isn't good for the street. ------------------ 95 GT convt' 5 speed, 3.73's,FMS HD clutch, Pro 5.0 shifter, ASP alum. underdrive pulleys, Bassani offroad X pipe, 2 chmbr flowmasters, K&N w/o silencer, edelbrock performer intake, FRPP 65mm T-body, FRPP shorty headers, FRPP aluminum driveshaft.Hooker 4pt chrome car bar, Xenon/Wings West ground effects, custom interior Best ET: 13.83 Best MPH: 98.55mph with Best 60': 1.91 on Nitto DR's Homepage: <A HREF="http://www.angelfire.com/pa2/killercanary" TARGET=_blank>http://www.angelfire