Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-16-2001, 10:19 PM
|
#4 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
I don't know about the specific kits, but here is a pic of the universal parts. I have put this setup on my 66 Mustang and my buddies 78 Vette. You get the center X and the four "legs". The legs are in their UN-CUT length in the pic
__________________
347 CHP shortblock, TFS TW, Stealth, 650 Holley, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, March serpentine pulley system, Richmond 6 spd, CFDF, Hyd. TOB, Currie 9" w/3.50, alum Drv Shft, susp mods, TCP subframes & tower braces, Trans Am Racing power dual master, 4 wheel disc, 17x8 Torqthrust II's Something up my sleeve  In a 66 coupe www.2mfffabshop.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| X vs H Pipes | Jason1320 | Modular Madness | 2 | 02-28-2004 08:16 PM |
| How big are the stock tail pipes and how restrictive are they? | 96_4.6 | Modular Madness | 4 | 12-09-2003 07:41 PM |
| Will 99+stang tail pipes fit 96-98?? | 96_4.6 | Modular Madness | 3 | 09-19-2002 05:50 PM |
| turn-down pipes TORQUE IS GONE!!! | FordFasteR | Windsor Power | 13 | 04-19-2002 07:10 AM |
| are mac's 3 1/2 inch tail pipes for my setup | Chevysucks | Windsor Power | 1 | 03-18-2002 03:46 PM |