Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-22-2003, 06:41 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Location: Madelia,MN USA
Posts: 58
|
Head studs, Any one here using them?
I would like to get head studs for my new engine build up but I have heared you can't pull your heads off with the motor in the car. I don't care if it is hard as hell to get them off with the motor in the car but does anyone know if it can be done? Thanks
__________________
331 stroker, JE 8.5:1 pistons, H-beam rods, steel crank, main cap, msd with 3step, BBK ceramic long tubes,TKO, 4.30's, motorsport Z303, Victor Jr aluminum heads, crane gold 1.6, southside lift bars, 90/10 front, 50/50 rear, centerforce dual friction clutch, Vortech S-trim soon. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best way to remove head studs? | Hozer 88GTConv | Windsor Power | 3 | 03-12-2004 07:59 PM |
| Head Studs | speedytang | Windsor Power | 3 | 09-17-2002 11:30 AM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| ARP Head Stud install | Prochrgd1 | Windsor Power | 7 | 03-27-2002 01:31 AM |