Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-31-2002, 01:39 PM
|
#9 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
Good comments above.
Are you running a BTM? If not, dial down the timing. Is the 14lb rating at the intake or the blower? If at the blower, you will lose ~3lbs through the intercooler - not that this is a bad thing. On a stock motor, 14# is ALOT. I know that mags have done this, but that is with some serious on site tuning by experienced mechanics. Just be careful! Have you had your car tuned? Plug gap should be ~.035 and should be at least one heat range cooler. How is the car idling? Are you running an FMU? Sorry for all the questions, but I've been away from the site for a couple weeks and haven't followed along with your install. Good luck, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Questions about Alky/Water injection with a positive displacement blower | stangsrule | Power Adders | 0 | 07-22-2003 12:58 PM |
| Another blower question | bigred90gt | Windsor Power | 2 | 01-12-2003 11:14 AM |
| Novi blower problem | exgmguy | Windsor Power | 3 | 05-18-2002 11:30 PM |
| Blower or n/a parts first: your thoughts? | Capri306 | Windsor Power | 5 | 06-05-2001 09:17 PM |
| Why 3:55 gears for blower cars? | Mike_W | Windsor Power | 2 | 05-26-2001 09:44 AM |