Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2004, 08:54 PM
|
#8 |
|
Registered Member
Join Date: Mar 2004
Location: Long Island
Posts: 58
|
I WOULD SAY UR PUTTING 275-290 TO THE FLYWHEEL.
PUT A SMALLER PULLY ON BLOWER...... IF YOUR BOTTOM END IS IN FAIR CONDITION, U SHOULD BE ABLE TO RUN 12-14 PSI.
__________________
1990 Mustang GT Engine- 308 (bored .40 over) Probe Forged pistons (10.5:1), Scat forged crank and rods, w/Main Girdle, AFR 185 heads, GT-40 intake, CSI electric water pump. AC delete kit, No smog pump, Manual rack and pinion steering. Ignition- MSD 6AL, MSD Blaster coil, MSD hellicore wires. Drive Train- Tremic 3550, Alum. Drive shaft, 3:73 gears, Stock carrier and axels. 26X11.5 M/T Et streets. Power adder- 175 shot of laughing gas. Best ET 11.5 @120mph on squeeze, 12.4 @109mph on muscle (on gt40 heads) on the 185 heads ... ??? tba |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power steering | RDRZ | Classic Mustangs | 0 | 03-02-2004 07:53 PM |
| power for 500 hp daily | Torinalth | Power Adders | 22 | 09-25-2003 11:54 PM |
| Lost top end power | bobtodd | Windsor Power | 11 | 08-01-2002 10:28 PM |
| power shift? | JamGtStang | Windsor Power | 6 | 03-01-2001 02:11 PM |
| Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |