Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-28-2001, 08:51 PM
|
#2 |
|
Registered Member
Join Date: Dec 1998
Location: Ft.Myers, FL.
Posts: 150
|
Most likely your sending unit, if you are going to do it i would suggest upgrading the fuel pump as there is no sense dropping the fuel tank twice. The sending unit for water temp is on the lower intake manifold and is bad, mine did the same thing. Use rtv black on the threads and make sure you ask for the unit for a guage. John
------------------ 89 Notch: ASP Pullies, K&N Air,Transgo shiftkit,Trans. cooler,FMS 3 core , FMS 4:10's, 1.5" cowl, cold air kit, hooker shorties(jet hot coated), O/R H-Pipe, ASP solid mounts, Energy Sus. Trans. Mnt. BBK 70mm TB, MSD 6al, Dual elec. fans, 5.0 Firepower Kit, Scorpion 1.6 RR's, Flowmasters, 73 mm MAF, cobra intake and crower #512 cam, |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Want White Face Gauges Any Opinions ? | 98GTNewbie | Appearance & Detailing | 0 | 08-28-2003 02:10 PM |
| Reverse lit gauges - oil, EGT, fuel | speedemn | Audio, Security, & Electronics | 2 | 05-24-2003 02:06 PM |
| Gauges?? | SleeperGT | Modular Madness | 2 | 03-03-2003 08:33 PM |
| Aftermarket gauges in 85 dash, wire breakdown inside | RUSTANG | Windsor Power | 2 | 02-12-2001 11:06 AM |
| trans temp, oil pressure gauges, install questions.... | 88COBRA | Windsor Power | 6 | 02-01-2001 12:38 PM |